Club Scrap is hosting a new challenge this month: Make it Mini. We're challenging you to create projects or pages half the size from their original.
I recently joined an ATC swap in the Club Scrap Chat group on Facebook. An ATC is an Artist Training Card measuring 2.5" x 3.5". I've accumulated dozens over my crafting years and love to use them on my scrapbook pages and cards. Currently I have them in a binder but I want to be able to display them in my craft room.
I took the directions from the Club Scrap Adobe Mini Magazine holder and made it even smaller.Score a 10 1/2" x 12" sheet of cardstock vertically at 3", 6 1/2" and 10".
Score horizontally at 3", 4 1/2", 7 1/2" and 9".
Trim vertically with the 1/2" score mark to the right at 7" and 3 1/2".
This will give you three equal pieces for the boxes.
Scored lines are in black.
Draw a line horizontally 2" up from the bottom on both left and right flaps.
Using a craft knife, trim as pictured below.
Fold up along the 1/2" scored line and fold in the edges to create a box. Adhere 3" end flaps together. Continue with the remaining boxes.
Line up the 3 boxes side by side and adhere the middle sides together to create one piece.
Wrap a 1 1/2" x 9 1/2" piece of book board with cardstock to create a solid base.
Adhere bottom flaps to base.
Decorate front as desired.
We would love to see your Make it Minis. Visit the Facebook Chat Group 08/20 Technique Challenge post to upload completed artwork in the comments section.
Original Club Scrap Stamper's Project: Mini Magazine Holder.
